Griffin charging station multidock manual

I then used some Sugru to mount the Orico hub at one end of the MultiDock, as well as to provide strain relief for the USB cable which is now soldered on to the MultiDock's main board in place of the original socket. I removed the PCB from the Orico hub, soldered a wire link across the momentary power button so that it powers up automatically, and tacked a couple of chunky wires on to the power pins from the DC barrel jack. Since I was removing 3 of the original ports to replace them with ports from the Orico hub, I figured there ought to be plenty of power available - especially since most of the devices won't go anywhere near the 3A 5V which it could theoretically supply per port - to skip fitting a separate power supply in for the Orico hub, and instead power it straight off the 12V output of the MultiDock's PSU. While removing the main PCB from the MultiDock in order to replace the USB socket with an internal USB cable (to plug into the Orico hub), I noticed that the internal power supply is quite potent - 12V 12.5A, or 150W. You can find the adaptor plate on Thingiverse.

With the panel-mount ports I bought (and probably most readily available ones, unless you can find slimline ones), it's necessary to cut a small chunk out plastic off the body of the panel-mount socket I could have designed an adaptor plate which didn't require this, but it would have been more difficult to print reliably, and would have made it bigger and bulkier. It took a few revisions, but once I'd got it dialled in, I printed a few off. I found some short USB extension leads with panel-mount ports on AliExpress, and once they arrived, I designed an adaptor plate to take the place of an original MultiDock riser card. It'd start to get cramped if you tried to fit more than 10 devices into the MultiDock anyway, so it's not terribly limiting. In order to maintain the external appearance of a stock MultiDock 2, and to remove the need to physically modify the enclosure, I decided to replace a few of the MultiDock's USB ports rather than add additional ports. Also, there is no official Quick Charge 3.0 support, and PowerIQ will likely do the job, but we still would've liked to see QC 3.0 onboard.With the init scripts for adb-server and stf now in place, and the stf init script tweaked to wait 10 seconds (for the wifi to connect) and automatically determine the Compute Stick's IP address to pass to `stf local`', nearly everything was set.

This means that you'll need to unplug it from the wall if you want to turn the charger off. However, there is no dedicated power button to turn the charger on or off. On paper, the PD 4 marks off just about all of the checkboxes that one could want. Plus, Anker offers an 18-month warranty if something goes awry with your charger. Anker ensures that this charger is compatible with all kinds of devices and will evenly distribute the necessary power based on the plugged devices. Not only is the Atom PD 4 small and lightweight enough to pack away in your bag, but you can also remove the wall cable to make it even more compact. The two additional USB-A ports take advantage of Anker's PowerIQ technology to ensure the best charging speeds for other devices. There are two USB-C ports with Power Delivery, capable of providing up to 100W of power with the correct cable. The new Anker PowerPort Atom PD 4 is perfect for those looking for a desktop solution capable of charging all of your devices, including the iPad Pro.

Griffin charging station multidock manual